Printing a test file

This article is part of: 3D-scanning-printing.

For this week's group assignement, I teamed up with Tue and David. We picked a test file from Thingiverse in order to test different features of one of the 3D printers we have in Fab Lab Barcelona, the Creality3D CR-10 S5 3D.

test file
test file

This file allows us to test these features:

  • z-height check
  • warp check
  • spike
  • hole in wall
  • raft test
  • overhang Steps 50° - 70°
  • 2 different extrusion widths: 0.48mm & 0.4mm

Slicing

To be able to print a 3D model, we have to send instructions to the printer, wich are written in g-code and tells the motors where to move. To prepare the g-code, we have to slice our 3D model (.STL), to simulate and anticipate how the model will be printed, according to the printer settings and gravity law.

cura lab
cura lab

At Fab Lab Barcelona, a computer with Ultimaker Cura is attached to the machines, with all the presets of the differents printers saved in it. It's therefore easier to directly use it in order to slice our model instead of searching the presets and install them on our personal laptop.

Specific settings that we had to specify

  • layer height: 0.25mm
  • Wall thickness: 0.8mm (= 2 lines)
  • Infill: 10%
  • Print speed: 60mm/s (= maximum for this printer)

Printing

The filament we use is a PLA 1.75mm. It's a plant-based material made from starches like soybeans or corn. It needs to be heated at 190-200C° to be used.

testfileprint
testfileprint

The printing was done in ~90 minutes without any troubles.

testprint
testprint
testdetail
testdetail

Results

As we can see in the images above, the definition of the print is quite good, the details are respected and the print angles can be large (in fact more than 45°). Even the small bridges without support were printed correctly. I am very satisfied with this test and the new possibilities that it lets us see.

Created 26/02/2020

Updated 26/02/2020